views:

177

answers:

1

I keep my source html (and images etc.) in separate directories for source control. Part of making the distro is to have make copy files to output folder and set the attributes.

Today my makefile shows (extract):

%.html:
    /usr/bin/install -c -p -m 644 $< $@ 

www: $(HTMLDST)/firmware.html $(HTMLDST)/firmware_status.html $(HTMLDST)/index.html
$(HTMLDST)/firmware.html: $(HTMLSRC)/firmware.html 
$(HTMLDST)/firmware_status.html: $(HTMLSRC)/firmware_status.html 
$(HTMLDST)/index.html: $(HTMLSRC)/index.html 

This is shown with only three html files, but in reality, there are lots.

I would like to just list the filenames (without paths) and have make do the comparison between source and destination and copy the files that have been updated.

Thank you in advance Søren

A: 

This should do it:

$(HTMLDST)/%.html: $(HTMLSRC)/%.html
    /usr/bin/install -c -p -m 644 $< $@ 

www: $(HTMLDST)/firmware.html $(HTMLDST)/firmware_status.html $(HTMLDST)/index.html

Or, for brevity:

HTMLFILES = firmware firmware_status index

DESTFILES = $(patsubst %,$(HTMLDST)/%.html,$(HTMLFILES))

$(HTMLDST)/%.html: $(HTMLSRC)/%.html
    /usr/bin/install -c -p -m 644 $< $@ 

.PHONY: www
www: $(DESTFILES)
Beta
Thanks a lot, just what I needed.
TheRoadrunner
@TheRoadrunner, my pleasure. Could you mark my answer "accepted"?
Beta