I have an Avnet ADS-XLX-V4FX-EVL12-G (Virtex4 Evaluation Board) with
OLED display. I used Xilinx EDK 10.1 with Xilinx Platform Studio 10.1
and succeded to upload some basic app to the board (serial
communication).
Now I would like to use the OLED display mounted on the board but I
have no ideea how to begin. I found the uCLinux distro f...
I need a flip flop that reacts on the edges of two different signals. Something like this:
if(rising_edge(sig1)) then
bit <= '0';
elsif(rising_edge(sig2)) then
bit <= '1';
end if;
Does such a flip flop exist or is there some other technique i could use?
I need this to be synthesizable on a Xilinx Virtex-5 FPGA.
Thanks
...
I'm designing a micro controller based around the microblaze microprocessor on a xilinx fpga. Most of the hardware setup is done. All I'm updating at this point is the c code to be run on the microblaze. Is there a way in XPS to not have to rebuild the entire project, just the c code portion. It takes around 20 minutes to rebuild the ent...